I have read and accept the Terms of use and the Privacy Policy
SHARINGYOURCHALLENGES
Sectors
Technologies
Go back
In forging the die change can be carried-out in many different ways. Dies are usually attached to the die-plates which are at the same time clamped to the press, both on the table and on the slide. These clamping interfaces can be done either through safety screws or hydraulically depending on the case.
Additionally, the accurate centering of the die, the ease of access to it and the protection of the mechanisms against the aggressive conditions under which the dies should work are taken into account in the design of each different project.
In FAGOR ARRASATE we help our customers to choose the most adequate reference change system according to the process requirement; for that we can adapt our design with numerous die changing arms, consoles and roll blocks and all the necessary features to make the reference change fast and easy.
Sectors Forging
Forging systems
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
It enables to check users’ preferences and further analyzing in order to improve and develop products and services. Gathering information is anonymous and occurs without personal data identification of particular user.
For video playback, this page uses third party platforms such as YouTube and Vimeo, among others, to conveniently serve videos. This Cookie is required to play video or audio. As a result, when you visit a page with embedded content, cookies may be installed from those websites. Fagor Arrasate does not exercise any control or responsibility over these cookies, so you should check the corresponding cookie policy of these third parties if you wish to obtain more information.